Keeping my board looking neat?
Moderator: Ghost Hip
-
Teej212
- FAMOUS
- Posts: 1675
- Joined: Sun Jun 14, 2009 5:08 pm
- Location: NJ
Keeping my board looking neat?
No matter how hard I try to arrange my pedals they never seem to look neat on the board. Majority of them at top mounted jacks too except for my EHX pedals. What are some tricks you guys use to keep your board looking neat a far as cable management? I'm using a DIY gorm board so I can easily tuck wires underneath.
-
MEC
- HERO
- Posts: 4651
- Joined: Sat Jan 01, 2011 4:04 pm
- Location: Old North State
Re: Keeping my board looking neat?
I go under the board when possible and use all of the same type of cables.
Lining them up straight and keeping similar spacing goes a long way too.
Maybe post a board pic for more specific advice.
Lining them up straight and keeping similar spacing goes a long way too.
Maybe post a board pic for more specific advice.
http://youthministry.bandcamp.com/
http://remainstheband.bandcamp.com/
Achtane wrote:FUZZ ALL DAY MAN FUZZ IS GOD ALL OTHER EFFECTS ARE SHIT
Caesar wrote:Dude, can you get the fuck out of my b/s/t thread with your bullshit.
PumpkinPieces wrote: This isn't America, this is I Love Fuzz.
Mudfuzz wrote:Remember when we were all just a bunch of weirdos that liked fucked up shit and not just a bunch of nerds buying bling to impress each other online?
-
Holy Schnikes
- Supporter
- Posts: 6587
- Joined: Thu Dec 09, 2010 3:05 pm
- Location: Taint Louis
Re: Keeping my board looking neat?
I use Lava solderless kits and use the shortest runs possible. They're extremely clean and reliable in my experience. Also simple to construct/modify.
I run all power from supplies stored under a removable floor, also very clean.
I run all power from supplies stored under a removable floor, also very clean.
univalve wrote:Boner on Fire Wallet Panties!