Forum rules
The DIY forum is for personal projects (things that are not for sale, not in production), info sharing, peer to peer assistance. No backdoor spamming (DIY posts that are actually advertisements for your business). No clones of in-production pedals. If you have concerns or questions, feel free to PM admin. Thanks so much!
Any clue where I could tap in to power a LED? Would change out the switch to make it work unless there's a more convenient way. Also -- on the site linked above, his unit came with a non-stock master volume knob. That would actually be a pretty handy add. Any clue where to stick a pot (and what might be a good value) in the output section to make that work? I'd feel more comfortable poking around in there if it weren't for the mains plug...
Hey, I know that blog! I don't know if Tim frequents this site though.
You can power the LED from a dropping resistor connected to +VS, and your bypass switch will actuate the ground connection. I would use something like a 2K7 for dropping resistor on that 13.5 volt rail, though anything between 1K and 10K should set you straight, depending on what you get for LED (with some of the hyper efficient water clears, my corneas benefit from something a little taller in the resistor department).
For an output volume, you could probably just replace that 33K ground reference resistor at the output with a 50K pot and connect the output line to the wiper instead of C20.
