ilovefuzz.com

Tldr: bypassed signal passes through. Muted when led is on

All of the wires soldered to the switch have good connections and pass continuity. I emailed Scott, but I'm not patient. Especially if it's something I can do myself.

Any ideas?????

https://youtu.be/iAoniPOpuFU

Turn the second knob down off of noon?

D.o.S. wrote:Turn the second knob down off of noon?

Ha! That's just a coincidence for the video.

My Ct5 did this (or something very similar) and it was a bad solder point on one of the jacks I think.

Send it to me. I'll either A)fix it or B)break it by accident. Your loss is your loss???

Sorry I'm absolutely no help. LOL

JonnyAngle wrote:All of the wires soldered to the switch have good connections and pass continuity. I emailed Scott, but I'm not patient. Especially if it's something I can do myself.

How far "in" have you confirmed continuity?

Have you measured voltages on the Vcc pins yet?

Bad switch, ja?

crochambeau wrote:

JonnyAngle wrote:All of the wires soldered to the switch have good connections and pass continuity. I emailed Scott, but I'm not patient. Especially if it's something I can do myself.

How far "in" have you confirmed continuity?

Have you measured voltages on the Vcc pins yet?

Nope

I tested to make sure all of the wires to and from the PCB are good. I don't know how to do diddly squat with a populated PCB. The switch is working, I tested that as well.

Shipping it to Canada, Scotty's going to get his mitts on it!!!