Page 3 of 3
Re: I would like to put over $1000 in parts & labor into my
Posted: Mon May 05, 2014 11:33 am
by Mudfuzz
You know, you might want to look at a schaller tune-o-matic roller bridge if you go the bigsby rout, and it "might" fit your post spacing.
Re: I would like to put over $1000 in parts & labor into my
Posted: Mon May 05, 2014 11:46 am
by Chankgeez
Thanks, Muddy, I'll look into that.
The Inter-Mark w/ the Bigsby bridge's in storage right now. So, I'd have to pull it out to see if any modifications are needed to get a Bigsby style bridge on there.
It looks like this four pickup guitar already had the bridge swapped out and then swapped back to the original one. So, I'm not really concerned about more holes in the body.
Re: I would like to put over $1000 in parts & labor into my
Posted: Mon May 05, 2014 8:43 pm
by Holy Schnikes
That Schaller roller bridge is really nice, the STM I think it is. I have one in satin chrome on my Bigsby equipped EGC and it's been a treat thus far.
Re: I would like to put over $1000 in parts & labor into my
Posted: Mon May 05, 2014 8:53 pm
by Chankgeez
Thanks, Schnikes. How much do they cost?
Re: I would like to put over $1000 in parts & labor into my
Posted: Mon May 05, 2014 9:10 pm
by Mudfuzz
$51.34
Re: I would like to put over $1000 in parts & labor into my
Posted: Mon May 05, 2014 9:13 pm
by Chankgeez
That's a bargain. Thanks, Muds.