EHX Cathedral Help

[seabrood]

Forgive me if this is in the wrong section, but I need some help with my Cathedral.

There's this latency issue every time I kick it on, it seems like the audio cuts out for a second. Like, if you had a chord ringing out and you press the footswitch to turn the effect on, the audio goes silent for a split second and then comes back with the reverb. It's really annoying when you're trying to add the reverb mid-song. Is this a thing any of you have experienced and have any of you found how to fix it? Or is it just a Cathedral thing?

[kbit]

Haven't experienced this with my Cathedral but that good old EHX quality doesn't surprise me. Try using a different power source to see if that relieves the issue. If not, I'd consider contacting EHX about a repair.

[tremolo3]

Doesn't happen with my gf's Cathedral
Are you using like 100% wet presets? Is the pre-delay set pretty high?

[Dandolin]

Your clean signal drops out too? It's easy to adjust Cathedral for non-intuitive results, but that shouldn't happen, unless...ramonovski has a point....

[seabrood]

I only have one 100% wet preset, and one with any predelay, but they all do it

[karmablock]

I haven't experienced this with mine. I've never had problems with EHX pedal besides the newer ones looking butt ugly.

[Jero]

Does it happen every time? Try pushing the switch a few times, not quite hard enough to actuate it. Anything? I've had faulty ones cause something like that.

[misterstomach]

I've never had that exact issue, but mine did some weird shit when I was running it with inadequate power. Usually related to saving presets or during switching. So I'd chech that first. It uses a pretty heavy load. 200 mA I think.