PCB / Jack / Power Wiring Question (Mellowtone Melx2 DIY)

kosta · Post by **kosta** » Wed Sep 19, 2012 12:36 am

Hey DIY folks. I have these 2 Melx2 PCB's that I'm trying to cascade into each other, but I can't for the life of me figure out how to wire them. I'm sure it's some obvious thing that someone more seasoned than myself could get sorted in a snap. There will eventually be 3PDT's and LED's and all that, but for right now I just want to wire them one in the other like this : Input >> Melx2 >> Melx2 >> Output

Anybody care to lend a hand?

: photo-4.JPG (304.34 KiB) Viewed 901 times

Thanks!

LaoWiz · Post by **LaoWiz** » Wed Sep 19, 2012 11:40 am

Yo, did you see this thread?
http://ilovefuzz.com/viewtopic.php?f=149&t=25766
Out of first board goes into in of second. Should be pretty easy if the diagram on the other thread is correct...

kosta · Post by **kosta** » Wed Sep 19, 2012 11:47 am

Dude I searched for that thread like 10x last night!!! Bless you sir.

LaoWiz · Post by **LaoWiz** » Wed Sep 19, 2012 3:54 pm

kosta wrote:Dude I searched for that thread like 10x last night!!! Bless you sir.

Sweet

ilovefuzz.com

PCB / Jack / Power Wiring Question (Mellowtone Melx2 DIY)

PCB / Jack / Power Wiring Question (Mellowtone Melx2 DIY)

Re: PCB / Jack / Power Wiring Question (Mellowtone Melx2 DIY

Re: PCB / Jack / Power Wiring Question (Mellowtone Melx2 DIY

Re: PCB / Jack / Power Wiring Question (Mellowtone Melx2 DIY