The purple PCB is a "Triple Cobra" Rev. B. One in, three out splitter. I published schematics on another forum; its nothing new under the sun. I'll email it to whomever would like a copy.
Here's a close-up of Rev. B:
And here is Rev. A:
Revision A is single sided, thus, waaaaaayyyyy cooler. I got lazy and I wanted the layout smaller, so I opted for a double sided PCB layout. Sorry to disappoint.
If I was into sweets, I'd be all over it; which is to say: I'm spongin what yer spillin
Most production pieces are built on 4-layer boards, although I only use two of them.
I really enjoy PCB layout and single sided has proven to be the most challenging, thus the most fun for me. It can be really tough to make a tight, attractive layout with only one layer to work with. To make it harder, I like to embed patterns and secret codes into the values and component placement. One of my favorites is to place low values on the left (or top), high values on the right (or bottom) and work the layout such that the signal path is short and the values increase as they are read: left to right.
its an arpegiattor. sort of lofi ish but not that lofi. also works like a EHX freeze except you can then arpegiate the "freeze" i will have some soon but i have been really tied up with school and some contract work.
its an arpegiattor. sort of lofi ish but not that lofi. also works like a EHX freeze except you can then arpegiate the "freeze" i will have some soon but i have been really tied up with school and some contract work.
Sounds really cool too. 
