Top Mounted Everything! And RRR v2 discussions!

[Ryan]

I'm sorry Guru! I hate to disappoint you with that news.. it's just a complicated issue that I'm not sure about.

[Companda]

Just let me have one. Then, I can show it off to everyone!

But, they can't touch it.

Only me.

[Ryan]

The voice of pure reason, as usual! *starts building Compy's RRRRRRv10*

[luke_duke]

I just died a little bit inside...

[Companda]

And I will live forever. My one and only RRR v2 will fuel my life force.


Also, I'll probably consume your soul. Who knows.

[Ryan]

Sorry Luke! This whole RRRv2 situation shouldn't be seen as a 'no', it's just an 'i don't know' for the time being.. the RRR's last stand is still to come and it'll be a doozie, I swear!

Compy, I thought we decided no more soul eating... cause you know, the calories and carbs...

[Raintes]

"pop 'em in the microwave for 3 minutes... there's mac and cheese inside"

There was NO mac and cheese inside my SDD. Just smoke and tons of melted thingamabobs. AND, it looks like I'll be needing a new microwave.

[Ryan]

Well, buddy... it would have been pretty cool though, hey?

[Raintes]

^ Yes it would've been frickin' rad!

[Raintes]

Sorry for the double post but this seems to be the "general Dr. Scientist discussion" thread...

anyways, Cleanness users, just wanted to find out where exactly on the pedal chain do you place yours at? I've heard to place them after dirt / fuzz but I've seen a few boards with 'em at the end of the chain. Is there a "proper" way of placing it? After delay / reverbs? after dirt?

[Ryan]

Boost/EQ are things that can work in lots of different places, depending on what you want to do... like if you want to colour your whole dry tone through the whole path, or if you want to just goose a certain pedal or two, or if you want to make your signal louder at the end... or quieter somewhere in between... there could be lots of spots to try it out!

If you're using it to goose dirt pedals then I think it's best before them, low gain into high gain kinda thing, but if you want to change the EQ of a dirt pedal then it might be better after.. or before.. you gotta try both!

Basically bub, you gotta stick that Cleanness before and after every single pedal on your board until you find the magic spot. (When you find the magic spot your Cleanness will start spinning at about a million rpm, so it's easy to tell)

[allicio]

Im glad this was asked as i was wondering the same thing. although Im thinking at the start like Ryan says a low to high gain kinda thing will be the best place to start on my board.