Stringing is a little tough, but I may grind away the bottom edge with a dremel a little to make some more room.
In case you ever wanted to block a Kahler
Moderator: Ghost Hip
-
Phosphene Audio
- committed
- Posts: 398
- Joined: Wed Dec 14, 2011 5:31 pm
In case you ever wanted to block a Kahler
Just remove the springs and cut a piece of ground buss to fit. I had to ream out two of the holes to make the screws line up.
Stringing is a little tough, but I may grind away the bottom edge with a dremel a little to make some more room.
Stringing is a little tough, but I may grind away the bottom edge with a dremel a little to make some more room.
-
Mudfuzz
- HERO
- Posts: 16705
- Joined: Sat Jul 07, 2007 7:06 pm
- Location: The gloomy lands of the northwest
Re: In case you ever wanted to block a Kahler
Did something go wrong with it or something?