Page 1 of 1
Muricans, powering question
Posted: Fri Jun 08, 2018 8:50 am
by Bon Hoga
I'm rearranging my pedalboard, replacing a passive ABY switcher with an active unit. Can I plug this 2-prong Radial power supply into the 3-prong courtesy outlet on my Pedal Power? If it makes any difference, I'm in Europe and the PP is plugged into a voltage converter.
Re: Muricans, powering question
Posted: Fri Jun 08, 2018 9:00 am
by calfzilla
Third prong is just for ground, so it shouldn't be an issue....
I accept no responsibility for consequences.
Re: Muricans, powering question
Posted: Fri Jun 08, 2018 9:35 am
by Bon Hoga
So, I shouldn't expect any noise or anything?
Re: Muricans, powering question
Posted: Fri Jun 08, 2018 9:43 am
by fuzzisokiguess
Reading this sentence with your inner voice and/or out loud releases me from all damage that may occur from following this advice.
As above- should be fine. No different than normal outlet as far as noise.
The one thing that may get you tho is the orientation of the convenience outlet (and the blades on the wall wart- one is probably taller than the other) may require the wall wart to be upside down, which may mess it fitting how you want.
Re: Muricans, powering question
Posted: Fri Jun 08, 2018 10:11 am
by Bon Hoga
fuzzisokiguess wrote:Reading this sentence with your inner voice and/or out loud releases me from all damage that may occur from following this advice.
As above- should be fine. No different than normal outlet as far as noise.
The one thing that may get you tho is the orientation of the convenience outlet (and the blades on the wall wart- one is probably taller than the other) may require the wall wart to be upside down, which may mess it fitting how you want.
Just flipped the PP, everything fits.