ilovefuzz.com

So say the Micro Pog mod where you can add an additional footswitch to recall a different setting...
How does one figure out if something like this is possible on a PCB board?

I have a Ditto X2 that I'm curious as to whether i can add another footswitch to the board to use as a stop switch, that way the other switch is left to use for the reverse/octave function.

Casavettes wrote:How does one figure out if something like this is possible on a PCB board?

https://en.wikipedia.org/wiki/The_Art_of_Electronics

however, if you asked a specific question about a specific PCB or schematic that actually had a link I could look at then I might attempt to help you mod it.