How hard would it be to Trails a new DD-3?
Posted: Mon May 16, 2016 1:23 am
Anyone tried this? The new production, not the old big-chip version.
Thanks!
Thanks!
Page 1 of 1
Re: How hard would it be to Trails a new DD-3?
Posted: Mon May 16, 2016 6:16 am
take the back off and show me pictures
Re: How hard would it be to Trails a new DD-3?
Posted: Tue May 17, 2016 11:34 pm
I haven't bought it yet!
I would assume it's this one:
I would assume it's this one:
Re: How hard would it be to Trails a new DD-3?
Posted: Wed May 18, 2016 3:21 am
if it is fet switching like the old ones then yeah not too hard. takes time and now two switches vs one footswitch. I only see one DIP IC and a ribbon cable, 3 FET's. I do not know if there is a daughter board and I do not know if it is some new software thing. buy it and find out.
Re: How hard would it be to Trails a new DD-3?
Posted: Wed May 18, 2016 12:39 pm
don't the dd's have trails? or is it just the newer ones?
Re: How hard would it be to Trails a new DD-3?
Posted: Wed May 18, 2016 7:39 pm
The dd-6&7 have trails, but don't sound as good, and most importantly, don't bend pitch the same with the time control.
Eatyourguitar- I'll grab one when the energy bar on my wallet replenishes and take gut shots galore.
Eatyourguitar- I'll grab one when the energy bar on my wallet replenishes and take gut shots galore.
Re: How hard would it be to Trails a new DD-3?
Posted: Wed May 18, 2016 8:47 pm
the old one had two outputs. you could probably just send the wet out to a passive mixer on the output jack. then disable the switching jack. you might need to bypass the wet fet switch on the output section of the wet. not hard if you have the schematic. probably move one wire and add a resistor.