Page 1 of 1
Enlcosure talk
Posted: Fri Jun 05, 2015 4:54 pm
by Jwar
hey dudes!
Does anyone know if a 125b tall exists??? I need one that's deeper. So annoying! Or a way to make one deeper. I'm open to suggestions.
I'm rehousing a Boss OC2, everything is perfect, but I realized the damn circuit board for this one is bigger than all the others I've done! So it won't fit with the jacks there.
Any thoughts?
Re: Enlcosure talk
Posted: Sat Jun 06, 2015 12:17 am
by culturejam
Maybe try using multiple bottom plates, and cut out the middle except for the last one?
Re: Enlcosure talk
Posted: Sat Jun 06, 2015 1:10 pm
by multi_s
wasn't there like some led base plate that would also be like what you suggested? like a transparent plastic ring that sat in between the base and top part.
Re: Enlcosure talk
Posted: Sat Jun 06, 2015 1:41 pm
by jrmy
I know that McSpunckle has made transparent plastic enclosure spacers for his pedals that have LEDs inside...
Re: Enlcosure talk
Posted: Sat Jun 06, 2015 6:23 pm
by Jwar
A transparent spacer would work PERFECT! Now where the hell do I get one. Smallbear and diystompboxes has the full ones, but for just a spacer? Any leads???
Re: Enlcosure talk
Posted: Sat Jun 06, 2015 6:50 pm
by lordgalvar
jwar wrote:A transparent spacer would work PERFECT! Now where the hell do I get one. Smallbear and diystompboxes has the full ones, but for just a spacer? Any leads???
Can your laser cut lucite? You can get that at home depot (for garage door windows).
How large of a spacer do you need. The lucite sheets are like 3/16 or 1/4 thick.
I don't remember how much of a taper there is or isn't on them but you could cut one in half and drill out the threads.