ilovefuzz.com

Figured since most of you can solder 100x better than I can, I'd post this here. It worked briefly, but when I use my Boss wall wart, the light on the wall wart blinks instead of staying solid, and the pedal no longer functions. I love the sound and I would like to fix it.


http://imgur.com/a/JQnaf

Photo no worky for me, but are the jacks loose? Can you move the knobs and they move the pot? Sometimes a jack will loosen and make contact with soemthing it shouldn't, like the tip shorting to ground/ chassis. Same with the pots - if they're loose they could be turned to the point where a lug makes contact to the enclosure.

If you carefully wiggle any part of the circuit board does it get life back?

Huge pics in NSFW. Link shoudl work now.

http://imgur.com/gallery/JQnaf/new

Is that LED still attached to the wires? It looks disconnected.

jwar wrote:Is that LED still attached to the wires? It looks disconnected.

The LED still lights up. I'm not sure if that is an issue.

Hmmm...Does it bypass? What happens when you hit the stomp?

I don't visually see anything wrong, but it's hard to tell.

jwar wrote:Hmmm...Does it bypass? What happens when you hit the stomp?

I don't visually see anything wrong, but it's hard to tell.

It bypasses, but when I hit the switch, nothing happens

xrleroyx wrote:

jwar wrote:Hmmm...Does it bypass? What happens when you hit the stomp?

I don't visually see anything wrong, but it's hard to tell.

It bypasses, but when I hit the switch, nothing happens

Could just be a bad stomp switch. I've had that happen a few times. They don't last forever unfortunately.

I'll give rewriring in a new one a go.

Have you tried running it with a battery?

MEC wrote:Have you tried running it with a battery?

That's a thought! Power supply. Didn't think of that. haha

Just tried with a battery and a ton of other supplies. No dice.

Going to try to rewire the footswitch tonight. Still isn't working. Many sad.