ilovefuzz.com

My DelayLab only works through the right channel, barely passing a signal through the left when on (it's very distorted and super quiet). I think this was caused by being in sub-freezing temps for 24 hours or so. Any ideas about how I can fix this? I can't see anything wrong visually, but I don't really know what to look for.


delaylab guts by Julius L Deane, on Flickr


delaylab guts by Julius L Deane, on Flickr

I'd check the solder joints on the jacks. One of them might have just gone bad. It's at least a place to start!

They'll all look fine. Maybe I need to get a multimeter? I'm a bit out of my element here.

Yeah you'd be able to check voltages and such with a multimeter. I'd also visually inspect the underside of the board for any solder joints that look like they might be weak or cold

fuck
i get major static at high vols
only through the channel that turns it on
not sure if thats right or left, ill check
but it seems these things aint takin a licking
maybe some other peeps will pipe up

dude that jag in your flickr is sick

ryan summit wrote:fuck
i get major static at high vols
only through the channel that turns it on
not sure if thats right or left, ill check
but it seems these things aint takin a licking
maybe some other peeps will pipe up

dude that jag in your flickr is sick

Thanks ryan!
It's the left channel, and that's also the one I have issues with. :/

looks like we got an epidemic
not really,but
do you notice it gets worse with volume increase?

Mine's virtually dead any way I've tried it.

Zombie thread solution!
It gut worse until the dry signal disappeared. Then I did a factory reset and it's basically back to normal! What?!