Page 1 of 1
THIS IS WHERE IT'S AT.
Posted: Thu Jan 30, 2014 1:54 pm
by D-Rainger
See that top pic? .... All you 'micro pedal' makers out there?????
The next paper mock-up.
Push button switches (OK-kickable) on bottom panel also shown in lower right pic.
Re: THIS IS WHERE IT'S AT.
Posted: Thu Jan 30, 2014 1:58 pm
by skullservant
SWEET MOTHER OF GOD
Re: THIS IS WHERE IT'S AT.
Posted: Thu Jan 30, 2014 2:05 pm
by coldbrightsunlight
That's some pretty impressive work!
Re: THIS IS WHERE IT'S AT.
Posted: Thu Jan 30, 2014 2:56 pm
by Chankgeez
Nice.
Re: THIS IS WHERE IT'S AT.
Posted: Thu Jan 30, 2014 6:24 pm
by Tristan
Karayzi!
Re: THIS IS WHERE IT'S AT.
Posted: Thu Jan 30, 2014 6:34 pm
by Doctor X
awww, thats so cute
Re: THIS IS WHERE IT'S AT.
Posted: Sat Feb 01, 2014 6:49 am
by goroth
So awesome D!
Re: THIS IS WHERE IT'S AT.
Posted: Sun Feb 02, 2014 10:02 am
by D-Rainger
Thanks guys!
I'm about to pull the trigger on the boxes...
Re: THIS IS WHERE IT'S AT.
Posted: Sun Feb 16, 2014 7:28 pm
by excane
AWWEESOOMMMEEEE
Re: THIS IS WHERE IT'S AT.
Posted: Sun Feb 16, 2014 8:24 pm
by intothegroove
Wow that's some very tight wiring
looks amazing though!
Re: THIS IS WHERE IT'S AT.
Posted: Mon Feb 17, 2014 6:19 pm
by D-Rainger
intothegroove wrote:Wow that's some very tight wiring
looks amazing though!
Thanks! Should work OK I think.... Could even have angled jackplugs OK.
I'm going to have small stabilising 'wings' on the sides of the baseplate - to compensate for no side sockets (extra stability - the only benefit of side sockets).