ilovefuzz.com

I've been thinking about starting my first pedal DIY. I have a well used Crybaby that I won't be using anymore. So I've been thinking about using the Crybaby shell to house a phaser. I'd probably base it around a Small Stone.

Any thoughts from ILF? Should I attempt to build my own or just rehouse a phaser? If I were to build my own, does anyone have any good schematics? Or are there any other pedals I should comsider housing in a Wah enclosure?


EDIT: I've also been thinking of turning it into a volume pedal since I don't have one of those either but that seems too boring.

Madbean pedals is releasing a Univibe board specifically to fit wah enclosures.

Are you thinking of just controlling the rate with the wah or the sweep?

Don't forget you'll need some kind of geared pot.

Scruffie wrote:Madbean pedals is releasing a Univibe board specifically to fit wah enclosures.

Are you thinking of just controlling the rate with the wah or the sweep?

Don't forget you'll need some kind of geared pot.

I was thinking the rate but I hadn't considered the sweep. I would be pretty interested in that Univibe board though. I'll look into that, thanks.

Also parts shouldn't be a problem; I'm an engineering student with lots of access to electronics labs.

MrNovember wrote:

Scruffie wrote:Madbean pedals is releasing a Univibe board specifically to fit wah enclosures.

Are you thinking of just controlling the rate with the wah or the sweep?

Don't forget you'll need some kind of geared pot.

I was thinking the rate but I hadn't considered the sweep. I would be pretty interested in that Univibe board though. I'll look into that, thanks.

Also parts shouldn't be a problem; I'm an engineering student with lots of access to electronics labs.

The EHX Bad Stone Phaser had a manual sweep control and in fact there was a version housed in a wah enclosure.

Bean is also releasing a board for this that would be great in a wah IMO, my favourite 6 stage phaser.