Page 1 of 3
To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:23 am
by askashrub
Do you:
a.) Love noise
b.) Use a gate
c.) Know magic
d.) Other
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:30 am
by sylnau
d) Evidence Audio, Monorail patch cable
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:45 am
by Chankgeez
e.) For Those About to Rock We Salute You?
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:50 am
by yallerhon
sylnau wrote:d) Evidence Audio, Monorail patch cable
Same same but different (Lava mini ELC here).
Also
e) Power supply with toroidal transformer &
isolated outputs.
I run 14? (too lazy to get up and check) pedals with no noise or hum. Only buffer is a TU-3 at the front, rest are TBP (which is not deliberate, there are plenty of buffered effects I'd like to own).
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:53 am
by Mudfuzz
f. own a TBLS
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:53 am
by Bellyheart
Need a power supply but for now the noise sounds good.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 9:54 am
by bigchiefbc
Good power supply (cioks AC10) + soldered up my own Mogami cables = no noise
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 10:49 am
by dubkitty
it's not that bad for now, so i put up with it. some of the not-so-badness may be due to the RV-3 buffer after the fuzz and/or the SERIOUS buffer in the TC chorus/flanger which is next to last in the chain. someday when i have money again i'm going to get an isolated power supply. the only time i've ever used a gate in my life was when i had a DBA Interstellar Overdriver Deluxe and had to use the gate because the triggered-vibrato mode was so noisy when not actually sounding a note.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 12:23 pm
by Demon666
I run anywhere between 13-16 pedals and have no noise. A good power supply and good cables should fix any problems you have.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 5:19 pm
by univalve
Demon666 wrote:A good power supply and good cables should fix any problems you have.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 5:29 pm
by behndy
bigchiefbc wrote:Good power supply (cioks AC10) + soldered up my own Mogami cables = no noise
this. i build my own longer cables, use good power supplies with isolated outs and make sure digital shtuff is always alone and i have a stupid buuts quiet setup running around 10 or 12 pedz i think.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 5:42 pm
by GardenoftheDead
I might be magic? The only noise comes from my single coils. I'm pretty sure my power supplies aren't transformer isolated, but I do have two separate ones. My cables are pretty horrible. I only run six pedals in a chain though, so my board isn't among the larger ones here.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 5:44 pm
by futuresailors
g) Giveth not a fuck.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 5:52 pm
by Waterpilot
Yeah I'm running 16 pedals with a power (two actually) supply and don't have much noise. My BB gives off some when not palying but I can just click it off.
Re: To those of you with massive pedal chains
Posted: Mon Jul 02, 2012 6:22 pm
by delaydecay
futuresailors wrote:g) Giveth not a fuck.
X 1000