ilovefuzz.com

Can someone please help me clarify some things with the electric brown.

http://www.etsy.com/listing/72385708/up ... t-lp-eb-ok

These are the instructions, but i need clarification about the sw1,sw2,sw3, and the pot hook ups.

Thanks

pot lugs are usually numbered like this...

so attach the corresponding numbers.

For the SW1-3, I'd say you don't need anything on them for the EB to work. They are likely for lofi/chaos/noise modes.

Thanks,

Is their anything thats special i need to know about the pot hook ups for the volume. It says output- volume pot 3. If i'm correct the volume pot 2 comes from the foot switch. So where does volume 1 go to?

volume 1 to ground

So does the control pot 2 to go to the solder pad that says input, or is this a correct way of wiring it up?
http://www.generalguitargadgets.com/dia ... a841b3e85a

I'm in over my head and need some noobie help

I'm not familiar with the kit, but looking at the schematic you need to connect the guitar signal "send" from the footswitch to lug 2 of the 100k pot: I think you can igore the pad marked "in" on the board.