ilovefuzz.com

I posted this over on TGP but didn't get a response...

I was wondering if it was possible/someone stocked just the lids for the MXR sized pedals? I need two or three (third for good measure/spare) so I don't ruin the finish on the bottom of my pedals when I put the new industrial velcro on there. I'll also need a Dr Scientist sized one (BB enclosure? I don't really DIY though I'd absolutely love to learn if someone local taught me) but I may ask Ryan if I can purchase a spare one.

Apologies in advance if this sounds silly to anyone and completely not necessary. I figured I got a PT-mini today after retiring my CNB case and figured I'm a skinny tie and a latte away from 'selling out' anyway (personal joke ) so I may as well take the extra step and secure my pedals well-being (they have feelings too, right? ) and get few new lids. Also means I can use them off the board too as I learned the hard way with a velcro'd pedal being on tiles...



Thanks again and man this has to be the longest ever thread/blabbering on about the most simple of requests...
It's been a slow day

If you haven't already, check with smallbear electronics, they have back plates for tawainese B (1590B-mxr size) and 125-B. maybe the first one is what you are looking for!!

My eyes are so shit

Thanks for that. I think I needed an affirmation of sorts and stood there going through them one by one (I'm not a DIY'er so any form of jargon goes over my head) and finally found them on like page 5. Thank you and yup, the first one looks like the 'MXR' sized ones. Will make my purchase after I post this

the plates will fit on a mxr but the mxr plate won't fit on a 1590B enclosure. I think mxr use bud industries enclosure. Or at least they used to but i tested it with my own pedals and its just like I said....you're going to be ok..