ilovefuzz.com

This is going to house a modded Russian Muff. I got so excited that I took a picture before smoothing out the decal.


I etched and drilled this board the other nice to test out a smaller layout for my upcoming run of Camel Sutra overdrives. You can see where I filled in with Sharpie hehe.


And here's my first pedal ever, which still doesn't work. I haven't seen in it years though, so I'm sure I would have no problem with it now. Note the tape holding the "decal" and labeling on.

heheheh, maybe this thread should be called the, "hey NBABMF: show us YOUR unfinished DIY projects!"



truthfully, the unfinished pedals end up as scrap, if i can't get it working i consider it hopeless and rip out the guts and start all over, salvaging whatever parts i can.... sounds extreme but trust me (as i'm sure you know) when it doesn't work, it's a HUGE disappointment.....

albeit, the more i do this, the higher the chances i build and get it up and running on the first feeding of voltage into the circuit... now THAT feels amazing....

LONG LIVE ILF DIY'ERS!!!!

Hey, I didn't remember that there was a work in progress thread until it popped up after I posted this one!