Page 2606 of 2752
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 12:11 pm
by JM Charcot
$harkToootth wrote:JM Charcot wrote:modulation and oscillation for 2020, waiting for a red panda particle v2 to complete the setup.
Consists of the organelle or any source ->
// Loop1 -> diamond compressor -> ehx freeze -> pitch fork -> eqd arpanoid -> sentimental bob tacana tremolo -> malekko bit reducer -> smallsound/bigsound tafm -> fairfield circuitry shallow water -> ss/bs mini
//Loop 2 -> zvex mastotron -> drolofx molecular disruptor -> strymon el capistan (sound on sound) -> boss dc-2w -> zoom ms70cdr -> eqd avalanche run
Loops come and go from the keith mcmillen k-mix, midi controlled by an evolution uc33e
I just saw this one. Big fan! Without hearing your choons... based off this... I am a big believer in whatever you are doing!
Thanks !
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 12:23 pm
by Zounds Perspex
pretty simple compared to most of you dudes, but
first in line is a cocked wah/MKI Bender, next is a Rangemaster. not pictured - I usually have Randy's Revenge somewhere in the chain. I power the delay and tuner with a Volto.
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 12:27 pm
by JonnyAngle
Zounds Perspex wrote:pretty simple compared to most of you dudes, but
first in line is a cocked wah/MKI Bender, next is a Rangemaster. not pictured - I usually have Randy's Revenge somewhere in the chain. I power the delay and tuner with a Volto.
Sicc aesthetic
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 12:27 pm
by Chankgeez
This page!
Also, this should be a band name:
UglyCasanova wrote: Jwarish
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 2:35 pm
by qersty
luv the trapezoid cast iron boxes
how do you make a rangemaster have 3(!) controls though?
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 4:15 pm
by ognoy
Tuner > Volume > Zvex Double Rock > Volante > MS70(mostly for reverbs) > Supa-Trem 2 > RC3.
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 4:39 pm
by coldbrightsunlight
qersty wrote:luv the trapezoid cast iron boxes
how do you make a rangemaster have 3(!) controls though?
The smallsound bigsound sparkle motion was a rangemaster with 5 controls! And I've breadboarded one with 4 that was great. I talk about doing that again every year and yet it's never become an actual pedal.
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 5:01 pm
by Zounds Perspex
qersty wrote:luv the trapezoid cast iron boxes
how do you make a rangemaster have 3(!) controls though?
volume, bias, and tone that takes it from classic treble boost to full range.
Re: Let's see your PEDAL BOARD!
Posted: Mon Jan 13, 2020 5:11 pm
by coldbrightsunlight
Those are the key ones!
Re: Let's see your PEDAL BOARD!
Posted: Tue Jan 14, 2020 6:39 am
by qersty
Really? I thought gain and bias was the same pot on the rangmaster? (there is some fancy word for this) 5 knobs is nuts
Re: Let's see your PEDAL BOARD!
Posted: Tue Jan 14, 2020 7:39 am
by coldbrightsunlight
It's not really that nuts
basically there's one "classic rangemaster" setting with the bias set in a particular position and the tone control (this is varying the input capacitor iirc) at max. Everything else does other sounds. Can be turned into more of a midrange boost and get a bit overdriven
Re: Let's see your PEDAL BOARD!
Posted: Tue Jan 14, 2020 9:39 am
by qersty
idk for a treble booster it is pretty nuts! most of the old ones didn't have a gain knob! Does it do the rangemaster thing where it peaks at ~1k with the volume up and becomes a more literal treble boost as you roll off?
Re: Let's see your PEDAL BOARD!
Posted: Tue Jan 14, 2020 10:01 am
by coldbrightsunlight
I can't quite remember to be honest I sold it years ago. The one I breadboarded (silicon rangemaster) boosted roughly the same frequency no matter where the volume was if I remember right.
You're right it's a lot of controls "for a treble booster", because what they all tend to do is turn it into other things!!
Re: Let's see your PEDAL BOARD!
Posted: Tue Jan 14, 2020 12:15 pm
by Olin
ognoy wrote:
Tuner > Volume > Zvex Double Rock > Volante > MS70(mostly for reverbs) > Supa-Trem 2 > RC3.
Always like your board/setup in general, this rendition is especially cool. What're your thoughts on the Volante?
Re: Let's see your PEDAL BOARD!
Posted: Tue Jan 14, 2020 3:05 pm
by ognoy
Thanks!
Love the Volante. Could probably spend more time with it and make some rad presets, but I usually only use the sound that is dialed in and the looper. LOOOOVE the looper. The best part of this pedal.