Page 2592 of 2752
Re: Let's see your PEDAL BOARD!
Posted: Wed Aug 28, 2019 5:45 pm
by alcohol.won
UglyCasanova wrote:Setup for ILFEU
Fuzz-E-Cat > Pladask Kniv with Enzo and Dronerainger in loop > Corazòn > Frazz > Meatbox > BioMoon prototype > Stammen
How do you like the Drone Rainger? How do you use it? I remember watching demos of it, seemed dope as fuck. Is it dope as fuck?
Re: Let's see your PEDAL BOARD!
Posted: Wed Aug 28, 2019 6:04 pm
by UglyCasanova
I got it, I put in on my board for the ILFEU meet up this weekend. That's all I've got for now.
I'll report back once I've messed with it.
Re: Let's see your PEDAL BOARD!
Posted: Thu Aug 29, 2019 3:26 am
by Dowi
UglyCasanova wrote:Setup for ILFEU
Fuzz-E-Cat > Pladask Kniv with Enzo and Dronerainger in loop > Corazòn > Frazz > Meatbox > BioMoon prototype > Stammen
Love this setup, Bitquest disappeared to make room for the Biological Moon? Wish I was t ILFEU to hear it.
Christophe wrote:Bigger board is almost ready. meanwhile, here's my first two-amp board:
Signal chain: Tu --> Mini --> RC boost --> Freeze --> DMM --> Lal 88 --> Bitquest --> A/B split --> ehx 720 --> A side: Memory Loss // B side: DD5
That board is a blast!
I've been using it for a few months and I'm just amazed at the possibilities. It's not that many pedals but a lot of them have hidden/secondary functions, and they pair so well together... I really love this selection for the way these pedals match together...
Rc boost is always on. Fave 88 setting: 1-2-3-6 down. Use the Bitquest mainly for bitcrush or ring (love the verb on the ring mode!). ML can be a fucked up delay on only one amp, or fuzz on only one amp!
Nice two amp setup, I like the fact that you have everything together and then two different delays for the two channels
Re: Let's see your PEDAL BOARD!
Posted: Thu Aug 29, 2019 4:36 am
by Christophe
Dowi wrote:
Christophe wrote:
Signal chain: Tu --> Mini --> RC boost --> Freeze --> DMM --> Lal 88 --> Bitquest --> A/B split --> ehx 720 --> A side: Memory Loss // B side: DD5
Nice two amp setup, I like the fact that you have everything together and then two different delays for the two channels
Thanks. Yeah, with the A/B before the looper, I can dispatch layers to the left or to the right channel. This brings more clarity when recording multiple layers, and it can also give the illusion that there's two guitars...
The 2 delays are more than enough to work on the loops if I feel like it. DMM on both sides + reverse DD5 on one channel is glorious! The Memory Loss/Kompact Kassette is heavy on the wet side, it works great with the two amp situation.
Re: Let's see your PEDAL BOARD!
Posted: Thu Aug 29, 2019 9:32 am
by VREEEEVROOOOOW
My pedalboard is finally pretty done! But I don't have a camera.
Re: Let's see your PEDAL BOARD!
Posted: Thu Aug 29, 2019 10:46 am
by JM Charcot
.
Re: Let's see your PEDAL BOARD!
Posted: Thu Aug 29, 2019 10:10 pm
by IBNYX
Tryna be more active here (maybe annoyingly so)! Here’s my current board; Swapped out the Multistomp for the LM-2, got the Model feT (which is the freakin’ greatest), have just done a ton of maintenance!
I may swap the tuner to the multistomp for more non-dirt options, and I have a Doom Bloom clone in the mail that is probably gonna upend my whole dirt section.
I accidentally used industrial strength dual-lock on this whole board so I’m gonna have to MAJORLY fuck it up to get everything situated.
Re: Let's see your PEDAL BOARD!
Posted: Thu Aug 29, 2019 11:21 pm
by alexsga
very nice what are the three in the top right hand corner?
Re: Let's see your PEDAL BOARD!
Posted: Fri Aug 30, 2019 1:08 am
by systemofameow
I've been wanting a Model Fet again pretty damn bad.
Re: Let's see your PEDAL BOARD!
Posted: Fri Aug 30, 2019 2:25 pm
by IBNYX
alexsga wrote:very nice what are the three in the top right hand corner?
From R-L:
Luna Audio Basalt (2-Stage Op-Amp Muff w/o tone stack)
DMB Stellar Drive (Rat-based OD, kinda like if a rat and a klon had a baby)
Op-Amp Muff. The 2nd footswitch is a mids toggle, and the toggle switch is a gate.
Re: Let's see your PEDAL BOARD!
Posted: Fri Aug 30, 2019 3:14 pm
by hbombgraphics
that's killer!!!!!
What's in the LS-2 chains? How are you using it?
Re: Let's see your PEDAL BOARD!
Posted: Sat Aug 31, 2019 6:21 am
by Pepsihillo
I've gone minimalist lately...
Tuner - TC Sub 'n Up - Ram's head Big Muff clone - Pigtronix Quantum - DR Scientist Tremolessence - Gurus Echosex 2 - TC Hall Of Fame mini.
Board is a small Harley Benton spaceship and power comes from a Palmer power plant under the board.
Not a big board and there's nothing too crazy on it, but I can get a lot of stuff done with this.
Re: Let's see your PEDAL BOARD!
Posted: Sat Aug 31, 2019 8:42 am
by IBNYX
hbombgraphics wrote:that's killer!!!!!
What's in the LS-2 chains? How are you using it?
I use it as an amp/channel switch; Loop A has the preamp section of the Quilter, and Loop B has the Model feT in it, and then it runs DD-500 > Deco > Tuner > Limiter > Power Amp
Re: Let's see your PEDAL BOARD!
Posted: Wed Sep 04, 2019 7:54 pm
by sylnau
Just finish this one… so far I like it a lot.
- IMG_3184.jpg (81.83 KiB) Viewed 4072 times
Re: Let's see your PEDAL BOARD!
Posted: Wed Sep 04, 2019 7:58 pm
by Chankgeez
sylnau wrote:Just finish this one… so far I like it a lot.
