Page 3 of 3
Re: Demo Video for the Elements, high gain mode
Posted: Fri May 06, 2011 1:51 pm
by toescantalk
Do we have the low gain demo yet? Very keen to hear if this is going to be my 5th Dr S pedal.
Re: Demo Video for the Elements, high gain mode
Posted: Fri May 06, 2011 7:10 pm
by Ryan
I haven't yet, I'm sorry. *hangs head in shame*
Re: Demo Video for the Elements, high gain mode
Posted: Fri May 06, 2011 8:14 pm
by sylnau
Ryan wrote:I haven't yet, I'm sorry. *hangs head in shame*
If it's doing same has the Cleanness (clean boost + EQ to low gain) + extra clipping and bass + mids freq... we already know it's going to be awsome!!
Ryan... Which setup (switch configuration) will be exactly same has the Cleanness (clean setup, no drive).
Re: Demo Video for the Elements, high gain mode
Posted: Mon May 09, 2011 4:05 pm
by Ryan
To make the Elements be a Cleanness you put the high/low gain toggle switch in the low position. Then you put the clipping toggle switch in the middle position, no clipping diodes. And that's that, you're in clean boost mode and can set the EQ/gain/volume however you like. The Elements has a bit more tone control than the Cleanness since you have a toggle for the midrange frequency and a toggle for the bass amount.
One plan I had for the Cleanness was to add clipping diodes to it if I ever did an overhaul of it, so the Elements is kind of where the Cleanness would have gone plus another gain stage for a lot more distortion.
The box has been approved and the artwork will be submitted tomorrow or Wednesday and then we'll just be waiting for the boxes to arrive, so I'm still saying right around a month. And I won't make the same shipping mistake again that I did recently with the Tremolessence parts. *smacks forehead for the millionth time*
Re: Demo Video for the Elements, high gain mode
Posted: Mon May 09, 2011 5:08 pm
by sylnau
Ryan wrote:To make the Elements be a Cleanness you put the high/low gain toggle switch in the low position. Then you put the clipping toggle switch in the middle position, no clipping diodes. And that's that, you're in clean boost mode and can set the EQ/gain/volume however you like. The Elements has a bit more tone control than the Cleanness since you have a toggle for the midrange frequency and a toggle for the bass amount.
One plan I had for the Cleanness was to add clipping diodes to it if I ever did an overhaul of it, so the Elements is kind of where the Cleanness would have gone plus another gain stage for a lot more distortion.
The box has been approved and the artwork will be submitted tomorrow or Wednesday and then we'll just be waiting for the boxes to arrive, so I'm still saying right around a month. And I won't make the same shipping mistake again that I did recently with the Tremolessence parts. *smacks forehead for the millionth time*
YEAH!!!!