Page 2 of 2

Re: BYOC large beaver rams head need some help

Posted: Tue Nov 24, 2015 3:22 pm
by Zzombie
well i belive its a goner the led wouldnt light up but i would get a hum from it in one position and nothing in the next

Re: BYOC large beaver rams head need some help

Posted: Tue Nov 24, 2015 3:23 pm
by Zzombie
also i may have made a mistake with the transformers, i looked at pictures of peoples but i didnt find much info on them and the actual circuit may be bad. It just kinda said put in transformers without a listing of what was what so i went for it based of a picture. Oh well i had fun while it lasted.

Re: BYOC large beaver rams head need some help

Posted: Tue Nov 24, 2015 5:48 pm
by crochambeau
Transformers?

I thought this was a Big Muff inspired clone, are there published build documents?

Re: BYOC large beaver rams head need some help

Posted: Wed Nov 25, 2015 10:00 pm
by Zzombie
http://byocelectronics.com/beaverinstructions.pdf for instructions, shows my knowledge i should have put capacitors. When it gets to that section it kinda gets left of and not much labeling in the packages of capacitors so i may have blown it on that. like i said i get a nothing sound then a humm but no led or any sound.

Re: BYOC large beaver rams head need some help

Posted: Wed Nov 25, 2015 10:03 pm
by Zzombie
on a side note i did just find this site http://shop.pedalparts.co.uk/ which sells a kit for most of the muff varients out there i may give it a go after a payday.