Page 2 of 2
Re: Thickest meanest and cheapest fuzz?
Posted: Tue Sep 02, 2014 2:18 pm
by digi2t
Uglyface.
Pretty cheap, parts-wise. Just need someone to build it for you, if you can't yourself.
Re: Thickest meanest and cheapest fuzz?
Posted: Tue Sep 02, 2014 4:27 pm
by frigid midget
Huge FZ-2 fan here. It kicked quite a few booteek peds of my board. I'll take an FZ-2 over any 'real' superfuzz replica, and as far as cutting through a mix, it beats all the fuzz face or muff variants I tried so far. The behringer clone is supposedly close enough, and a used one wil costs you less than a good steak diner.
If I had to go with something else that's cheap, but more velcro/glitchy sounding: Zoom UF-1.
Re: Thickest meanest and cheapest fuzz?
Posted: Tue Sep 02, 2014 4:37 pm
by K2000
Meathead clone
Re: Thickest meanest and cheapest fuzz?
Posted: Wed Sep 03, 2014 11:56 am
by voerking
adapt wrote:danelectro cool cat fuzz v1, accept no substitutes
this is exactly what i was going to post.
Re: Thickest meanest and cheapest fuzz?
Posted: Wed Sep 03, 2014 12:12 pm
by ThurberMingus
I tried the French Toast into the Behringer Muff and it fit the requirements. Now I just need my FZ-2 back from a friend and I'll be all set!
Re: Thickest meanest and cheapest fuzz?
Posted: Wed Sep 03, 2014 1:11 pm
by kbit
Tone Machine into Muff is a beastly combination. Good on you
