Page 2 of 2

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 12:37 pm
by AxAxSxS
Made my latest board from scrap wood. Cut down to a reasonable size, sanded and stained, and then added plexi for the upper decks :)

Image

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 12:38 pm
by Gone Fission
Hacken wrote:
pallbjörn.jpg
Got to get one of these then!
You can race those like scooters around a warehouse if you work for a poorly managed company. So most places with a warehouse.

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 12:47 pm
by spaceanomaly
AxAxSxS wrote:Made my latest board from scrap wood. Cut down to a reasonable size, sanded and stained, and then added plexi for the upper decks :)

Image
Niiiiiiiiice. Where you get the plexi?

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 1:32 pm
by sylnau
spaceanomaly wrote:Niiiiiiiiice. Where you get the plexi?
Inside the supermarket. :D

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 2:07 pm
by Achtane
psst
Reminder that pallets sittin' around outside may be kinda moldy or funky otherwise.
Also, a little bit of paint goes a loooong way toward not getting splintered up.

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 2:43 pm
by KaosCill8r
Pallets are a great source of cheap timber. I once built a huge grow room in my garage from pallets. Also "acquired" all the insulation from the same building sites. Saved a heap of $$$ and made a heap of $$$ from the results so it was a win win in my books.

My pedal board is made of recycled chests of draws and other "acquired" timber and shoplifted hardware and spray paint.

But yeah, pallet pedalboard is a great idea. But as stated earlier there is the potential for a lot of splinters. Get your hands on a belt sander It will save a lot of time and your hands. :thumb:

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 3:22 pm
by spaceanomaly
sylnau wrote:
spaceanomaly wrote:Niiiiiiiiice. Where you get the plexi?
Inside the supermarket. :D
AHHHHHH!!!!! eheh :thumb:

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 3:24 pm
by spaceanomaly
KaosCill8r wrote:Pallets are a great source of cheap timber. I once built a huge grow room in my garage from pallets. Also "acquired" all the insulation from the same building sites. Saved a heap of $$$ and made a heap of $$$ from the results so it was a win win in my books.

My pedal board is made of recycled chests of draws and other "acquired" timber and shoplifted hardware and spray paint.

But yeah, pallet pedalboard is a great idea. But as stated earlier there is the potential for a lot of splinters. Get your hands on a belt sander It will save a lot of time and your hands. :thumb:
Sure will Kaos. :thumb:

Re: PALLETBOARD

Posted: Fri Jul 04, 2014 10:29 pm
by ryan summit
belt sanders and pallets?
this is getting out of hand
set that pallet on fire if you hate the guy
and check your pms in a minute

Re: PALLETBOARD

Posted: Sat Jul 05, 2014 9:39 am
by spaceanomaly
ryan summit wrote:belt sanders and pallets?
this is getting out of hand
set that pallet on fire if you hate the guy
and check your pms in a minute
ahah. sure man :thumb: