Page 2 of 16
Re: The BitQuest User Settings Thread
Posted: Sat Apr 26, 2014 5:11 pm
by goroth
Will try it bro!
Re: The BitQuest User Settings Thread
Posted: Wed Apr 30, 2014 10:02 am
by Sparrow
i hope to get an iphone .. or something to have actual video of the pedals.
But. here's a Vid of that "universal" setting i posted.
[youtube]http://www.youtube.com/watch?v=NtaNppp2eyo[/youtube]
Re: The BitQuest User Settings Thread
Posted: Thu May 01, 2014 3:25 pm
by goroth
[youtube]http://www.youtube.com/watch?v=5BgDwUKEEXY[/youtube]
Filterzzzz!
Re: The BitQuest User Settings Thread
Posted: Thu May 01, 2014 3:29 pm
by goroth
Sparrow wrote:i hope to get an iphone .. or something to have actual video of the pedals.
But. here's a Vid of that "universal" setting i posted.
[youtube]http://www.youtube.com/watch?v=NtaNppp2eyo[/youtube]
This is so good!! How did you get that crackly static at around 30 seconds?
Re: The BitQuest User Settings Thread
Posted: Thu May 01, 2014 4:15 pm
by Sparrow
Dude! your Filter Demo is so cool
i really like around 4 minutes in!
thanks. on the setting i posted. set to clean delay. with Ctrl 0 off .. then i started slowly moving the Ctrl 0.
very slow. and that's what happened.
the delay signal starts glitching out / and creates that cool static.
p.s. that AB synth .. Neat!
Re: The BitQuest User Settings Thread
Posted: Sun May 04, 2014 7:30 pm
by Ryan
Totally awesome demos, Josh and Matt, thank you guys! They rule! You guys have filled up my YouTube playlist with such fun sounds, really nicely done and very muchly appreciated.
Re: The BitQuest User Settings Thread
Posted: Thu May 15, 2014 1:26 am
by Sparrow
CTRL 0.
[youtube]http://www.youtube.com/watch?v=2dRhMA_cLdM[/youtube]
Re: The BitQuest User Settings Thread
Posted: Fri May 16, 2014 12:25 pm
by Ryan
haha super weird, Josh!
Re: The BitQuest User Settings Thread
Posted: Tue May 20, 2014 10:12 pm
by Sparrow
thanks Ryan. and .. Literally .. that ain't half of the Weird sounds i've found
i just really like that 0 ctrl on the Clean delay. and Bringing it to LIFE
Re: The BitQuest User Settings Thread
Posted: Wed May 21, 2014 12:54 am
by neonblack
Has anyone used this on bass? I imagine its pretty friendly, just wanted to check.
Also, where do you find it most useful in your chain?
Re: The BitQuest User Settings Thread
Posted: Sun May 25, 2014 7:09 pm
by Sparrow
hey Neon. it`s been a few years since i`ve had a bass on tap. ( maybe someone else can chime in? )
i Have tried it all over my chain. before my other delay and reverb is where i like it. But. i haven't found a bad spot yet.
and .. i have tried it in a Lot of positions
i think it depends how you want to set it.
i tend to use it as a clean mod. device. so i put it later.
but . i could see it being setup - close to your Guitar as a Dirty Flange etc.
Re: The BitQuest User Settings Thread
Posted: Sun May 25, 2014 7:11 pm
by Sparrow
[youtube]http://www.youtube.com/watch?v=7Qmh1l68ZoQ[/youtube]
Clean Delay Ramping.
Re: The BitQuest User Settings Thread
Posted: Sun May 25, 2014 7:55 pm
by neonblack
I just wasnt sure where the bit crushing or pitch shifting would be best. do i want to crush my fuzz or fuzz my bits? I might just stick it right in the middle haha
Re: The BitQuest User Settings Thread
Posted: Sun May 25, 2014 8:19 pm
by Sparrow
neonblack wrote: do i want to crush my fuzz or fuzz my bits? I might just stick it right in the middle haha
we all have that Big decision
Re: The BitQuest User Settings Thread
Posted: Sun May 25, 2014 8:44 pm
by Jwar
I made a bass demo is anyone is interested. I'll work on getting it loaded up.