pedal-o-graphic / alumni / custom topic

[goroth]

That's nuts!!!

[autopilot]

forgot that, each fx has the option to sync one of the parameters to the LFO

[autopilot]

Brainzilla 3/4/5 Step Sequencer to control the wobbledzilla, it has tap out, and to jacks to feed the wobbledzilla, toggle for manual scrolling/trigger the sequencer steps, and the option to reset manually or select that it goes to reset when the wobbledzilla is bypassed or to let the sequencer always running

[goroth]

Holy Moses.

Would love to hear those two pedals in action. My brain is exploding just trying to get my head around the possible sounds.

[autopilot]

Portal : the way of the samurai (ghost dog movie artwork). Custom Portal version, blender/mixer box with 2 loops channels, that can be blended via knob on the pedal or via expression/cv signal, and the result of the mix can also be blended with the dry (only via the knob on the pedal), each channel has a vol and tone knob.

[autopilot]

Quad Broadcast: 4 independent outs, footswitch to select from LFO or external expression/cv input or fixed (knobs on the bottom side) for each out, rate/tap ratios can be synced to the expression / cv in, and tap or rate switch. The last 2 channel have a phase invertion, so they flip the direction

[autopilot]

Broadcast Supreme, 3 independent expression outs, exp /cv input to control the speed/ratios, manual control for each out and the amount of modulation on the main out. One channel is footswitcheable (the other 2 use toggles). CV out to expand the main out into more channels via broadband or bandwidth

[autopilot]

Custom Trek, 2 extra toggles, one is for the oscillation range (amount knob) and the other is to select if the width is controlled via the knob or the expression jack (the stock version as soon as you plug in the expression jack the width is controlled via the jack), this allow to be able to use an external source and not have to unplug the jack (tight pedalboard layouts)

the pedal in action:
https://www.youtube.com/watch?v=DeyE1oionqY

[autopilot]

Custom Caracol:
-Mode Swith now is a Footswitch.
-Expression/CV control of the cut knob.
-2 Oscillating modes, amount/pitch is controlled via a knob, and the type of oscillation is set by a 3 way the toggle (center off so it turns off the oscillation).
-Extra jack to activate externally the oscillation mode.
-3 way Voicing toggle for all the modes.
-Dry knob only available in the normal mode, when you switch to gainer mode the dry knob is out.
-Extra knob for the vol in the gainer mode.

The pedal in action:
https://www.youtube.com/watch?v=OUALLeRspTs
https://www.youtube.com/watch?v=Mwqr2KpH44k
https://www.youtube.com/watch?v=fBBlphZlDd4

[Tristan]

Yes!!!

[autopilot]

Custom Molecule:
-Filter section and VCA are in parallel (you can use both independently).
-External exp/cv input for the filter so you can plug an exp and use it as a wah/filter or LFO for a modulated filter or sequencer for step filter.
-PW knobs on both sections so you can set the pulse width of the modulation to taste.
-Oscillation Footswitch to send the filter to self oscillation with a rhythmic pulse and knob to fine tune the oscillation.

[youtube]http://www.youtube.com/watch?v=JFDm9Yzoqak[/youtube]

[univalve]

Your stuff is so hot! Someday i Need to get some more copilot in my life...

[autopilot]

slow broadcast is slow, the stock broadcast slowest sweep is around 18 seconds, this one goes to 360 seconds of slowness motion

[autopilot]

Custom Broadband, 5 independent expression outputs with range and aux knobs, dual input cv/exp sources, which you can assign to each out via the toggle on each output. So you can run a step sequencer and a triangle lfo as the input sources and assign one of them to each out (any combination, all can run the same source or your can assign to taste, or flip back on the fly to the other souce) and set the amount of sweep on each output via the range and aux knobs. The knob on the side is to manually sweep/control when there is nothing plugged into the cv aux.

[autopilot]

Custom Broadcast + 3/4/5 step sequencer controlling the tap ratios or the lfo rate. More info on my blog