After fitting the carpeted top into the tolexed frame, I installed and wired up all the electronics, as well as installing some straps (without which I would literally never be able to get the board out of its case). I used some pre-grometed tree landscaping straps with luggage handles added to them, and just bolted them on somewhat loosely, with liberal washer usage, so that they can be stored on top of the board when it's in its case (for ease of removal), but tucked under the board during usage. I apparently again neglected to document the pre-drilling of the holes for these straps, but I obviously did all that before adding the tolex. At this point the board was done, so the rest of these pictures are basically just porn.