Page 1 of 1
I'm building a bass INPUT NEEDED!
Posted:
Wed Jul 10, 2019 10:32 amby JonnyAngle
Robot Graves Neck
Gibson RD Body (Black)
2 Lace Alumitone Bass Bar 3.5 pickups (Chrome)
There are thee holes in the body
Should I go VVT, VT pickup selector, TT Pickup Selector, Vol Blend Toan? How would you wire this badboi?
Re: Bass Bodies
Posted:
Wed Jul 10, 2019 2:06 pmby JonnyAngle
GET HYPED!!!
Re: I'm building a bass
Posted:
Thu Jul 11, 2019 1:36 pmby JonnyAngle
The exact neck I'm getting:
- 2.JPG (64.62 KiB) Viewed 4491 times
The body pre-paint and routed to not my pickups:
- 1.JPG (20.98 KiB) Viewed 4491 times
The pickups:
Re: I'm building a bass INPUT NEEDED!
Posted:
Thu Jul 11, 2019 2:42 pmby odontophobia
Is that your neck or just the style you’re looking to have built?
Re: I'm building a bass INPUT NEEDED!
Posted:
Thu Jul 11, 2019 3:20 pmby JonnyAngle
odontophobia wrote:Is that your neck or just the style you’re looking to have built?
Unpolished with black block inlays
Re: I'm building a bass INPUT NEEDED!
Posted:
Fri Jul 12, 2019 12:00 pmby whoismarykelly
I'd wire it like a ripper and just put the tone/mid cut on a stacked pot. So you would have a volume pot, 4-way rotary pickup selector, and stacked tone/mid. That way you can have the max flexibility for your limited control set. Pickup positions cover all the popular bass tones:
Bridge only (music man)
Bridge and neck in parallel (jazz bass)
Bridge and neck in series (giant metal/doom/heavy bass tone)
Neck only (p bass)
Re: I'm building a bass INPUT NEEDED!
Posted:
Fri Jul 12, 2019 4:50 pmby JonnyAngle
whoismarykelly wrote:I'd wire it like a ripper and just put the tone/mid cut on a stacked pot. So you would have a volume pot, 4-way rotary pickup selector, and stacked tone/mid. That way you can have the max flexibility for your limited control set. Pickup positions cover all the popular bass tones:
Bridge only (music man)
Bridge and neck in parallel (jazz bass)
Bridge and neck in series (giant metal/doom/heavy bass tone)
Neck only (p bass)
Re: I'm building a bass INPUT NEEDED!
Posted:
Wed Sep 25, 2019 5:22 pmby JonnyAngle
bass is done. both pickups in parallel. Wired directly to jack. the volume knob is just for show at the moment.
- Capture.JPG (71.18 KiB) Viewed 4126 times
Re: I'm building a bass INPUT NEEDED!
Posted:
Sat Sep 28, 2019 4:28 pmby coldbrightsunlight
It looks amazing!!
Re: I'm building a bass INPUT NEEDED!
Posted:
Wed Oct 02, 2019 11:06 pmby kosta
If the body is thick enough for push-pull switches, I've been liking this combo for two pickup instruments:
- Three-way pickup selector switch
- Master Volume (phase reverse on the push-pull)
- Master Tone (series-parallel on the push-pull)
I did a P/J for a guy like that and the tonal options were pretty rad.