One of my main uses of the US is to max out the feedback and coarse rate knobs to generate a constant tone, then use the fine knob to tune to a pitch.
Right now the fine knob is a little too sensitive for my liking, so I'm looking for a way to decrease the range of the knob. Any suggestions like different pot values or soldering extra resistors?
Decreasing the range of the "Fine" knob on the Utter
Moderator: lawrence scaduto
-
p00n
- interested
- Posts: 37
- Joined: Mon Jan 25, 2010 9:57 am
-
lawrence scaduto
- committed
- Posts: 478
- Joined: Fri Jun 19, 2009 5:28 pm
- Location: Brooklyn, NY
- Contact:
Re: Decreasing the range of the "Fine" knob on the Utter
the fine knob is working at tenth of the coarse knob. it's a 2k pot. you could put a 1k in there and get half of what it does. or i could install that for ya.
I make Pedalshttp://ohnoho.com
I sell pedal parts http://bitcheslovemyswitches.com
thinking of PMing? email lawrence at ohnoho dot com for the quickest response
I sell pedal parts http://bitcheslovemyswitches.com
thinking of PMing? email lawrence at ohnoho dot com for the quickest response
-
Bellyheart
- IAMILFFAMOUS
- Posts: 5781
- Joined: Mon Nov 10, 2008 11:23 pm
- Location: Richmond, Va
- Contact:
Re: Decreasing the range of the "Fine" knob on the Utter
Have you tried using the other knobs? I do this often as well...sound great! I often adjust the volume or tone or feedback knob.
Not sure if that'll hep at all but they call me Two-bit. I hate the name.
Not sure if that'll hep at all but they call me Two-bit. I hate the name.