Hey guys, I'm thinking of building one based on the Beavis Audio's PCB less design which you hard wire the components point to point direct to the valve socket? Am going to be running it off a 12vdc power supply. Will be using last in the chain as a valve booster into my solid state bass amp.
Has anyone here built one from Dano's PCB less design?
Did you change any components or just go with Dano's stock layout?
Did you have any problems that need to be debugged?
What voltage do you run it at?
What rated tube do you run in it?
Is it worth building?
Have you tried it with bass?
Thanks for reading