warwick.hoy wrote:According to Voodoo Labs,...
The PPAC would power a Boomerang,...POD,...
My non expert deduction:
If the PPAC outputs enough current I could see you using it to power the Line6 M series.
I look at it as powering any pedal that wouldn't normally take a battery,...provided that the voltages match up.
What are you currently running as a powersupply. If the only wonky power requirements you have are for the Whammy,...I'd go with a PPII+ and run the Whammy with the stock wall wart off of the courtesy AC outlet and the rest of you board of the DC outputs.
Haven't posted my pedalboard in a while. It hasn't changed since the l past time I rearranged everything,...but I am currently thinking about a revamp.
This is just sort of a stream of consciousness/trying to determine what I want. My main gripe with this setup is that I don't have the Feedback Loop or any of the fuzzes going into my delay,...just the Ring Mod,...and while that is awesome,...I feel like I've limited the potential for the delay by not being able to put anything else into it.
The pro is that I can set the tap tempo on the DL-4 prior to switching over to it.
So I'm toying with the idea of revamping the signal chain and having everything except for the DL-4 and the Tuner going into the input of the LS-2,...then having the DL-4 go in a loop of the LS-2 so I can set tempos,...then be able to switch it into the signal and still be able to delay Fuzzes, Ringmod, MuRF and Feedback.
The Tuner would be the last thing in the signal chain before heading out to mah amp.
Any fault in mah logic?
That is a HELLA AWESOME setup as you have it now but I can see the usefulness of re-wiring like you said. Where does the Utter Stutter come into play? (where in the signal chain)
Funny, I was looking at the Utter a little while ago....ME WANTZ.